How to Build a WiFi To-Do List on E-Paper (ESP32 Tutorial)
This is a refresher post as we covered this previously - but I love this useful project so much!
E-paper is one of those displays that looks unremarkable in a photo and then completely changes your opinion the first time you use it: no backlight, readable in full sun, and it only draws power when the image actually changes. That last part makes it a genuinely good fit for a wearable or desk gadget you want to leave running for days on a small battery. This week's tutorial walks through the build behind Build This Genius To-Do List Gadget (ePaper + ESP32) — a WiFi-connected task list that updates itself and just sits there, legible, until you change it.
What you need
Everything below is bundled in the E-Paper To-Do List Video Kit if you'd rather not source it piece by piece, but here's what's actually doing the work:
- An ESP32-C3 SuperMini (or a QT Py ESP32-S2, if you want a smaller footprint — both variants are in the kit)
- A small e-paper module — I used the same class of panel as our standalone 2.13" e-paper module
- Basic hookup wire and, if you're building the wearable version, a bit of patience for soldering
- PlatformIO set up on your machine (if you're not there yet, my PlatformIO setup video covers the common build-failure traps)
The build, in four steps
1. Wire the display to the ESP32. E-paper modules typically talk over SPI, so you're connecting a handful of pins — clock, data, chip select, data/command, reset, and busy. Double-check your board's pinout before you solder anything; a mislabeled pin here is the single most common reason a first e-paper project doesn't boot.
2. Flash the firmware. The project uses a lightweight e-paper driver library and a basic WiFi connection routine. On first boot, the ESP32 joins your network and pulls down whatever's on your task list.
3. Handle partial refresh. This is the detail that makes or breaks an e-paper project: full-screen refreshes are what cause that flashing black-and-white flicker you may have seen in other people's e-paper builds. For a to-do list that updates one line at a time, you want partial refresh so only the changed area redraws — faster, and much easier on the display over its lifetime.
4. Mount it. Whether you're building the wearable version or a desk-standing one, e-paper is rigid enough to need a proper enclosure or fabric pocket — unlike a flexible LED strip, it won't forgive being bent.
Why I keep coming back to this project
I use mine constantly, which is honestly rare for something I originally built as a demo. It's the kind of project that's simple enough to finish in a weekend but touches on real skills — SPI communication, low-power display driving, and WiFi data fetching — that show up in much bigger projects down the line. It's also just genuinely satisfying to glance at a screen that isn't backlit and isn't nagging you with a notification.
Where to start
Watch the full build: Build This Genius To-Do List Gadget (ePaper + ESP32). Grab the exact kit used in the video: E-Paper To-Do List Video Kit — from $49.95 CAD.