Maker Corner: Spooky Season Lights, Tiny ESP32 Boards and Safer Batteries
Updated
It is that time of year when costume plans get ambitious and deadlines get very real. Halloween is October 31, and the Christmas wearables rush is right behind it. Here is a short roundup of what is on my bench and what might be useful on yours.
CMozGlow now has Halloween and Christmas themes
My CMozGlow library has been updated, and it now includes two new themes: Halloween and Christmas. They are meant to make it easy to add seasonal lighting effects to NeoPixel (WS2812) LEDs. If you build with ESP32 boards and PlatformIO, this is aimed squarely at you. If you are building a costume this week, add it early so you have time to tune the look on your actual garment rather than on the desk.
Test it out with our online interactive generator!
Start small with addressable LEDs
If you have never used NeoPixels, you do not need a big strip. A single ring is a satisfying first project because every pixel is individually controllable from one data pin. The 8-Bit WS2812 RGB LED Ring Module is a compact option that fits on a hat, a bag strap or a brooch. If you want to try a strip before committing, the Starter Strip: 10 WS2812b strip is a low-cost way to test colours and patterns. My video on sparkling up your fashion with NeoPixels walks through wiring them to an ESP32.
Pocket-sized ESP32 for tight costumes
Wearables have a space problem. The ESP32 C3 SuperMini Development Board (Pink) is a thumb-sized board with WiFi and Bluetooth LE and a USB-C port, and it is a good fit when a full-size dev board will not hide under a sleeve. It works with PlatformIO and Arduino-style code, so your existing habits carry over. If you are new to the toolchain, my ESP32 for Beginners video is a good place to start.
Battery notes for costumes
Lighting projects are only fun when they stay powered, and a costume is a rough environment for a battery. We have added several new LiPo options, including a 110mAh cell with a JST PH 2.0 connector for tiny builds and a 600mAh bare-wire cell for projects that need more run time. A few reminders: confirm the connector polarity matches your board before plugging in, protect the cell from being crushed or pierced, and keep it where it will not get pinched. More LEDs at higher brightness draw more current, so a modest brightness setting will stretch your battery and keep a garment more comfortable to wear.
Something to admire
If you would rather wear a finished piece than build one, our limited Light-Up Matrix Necklaces are made by hand in Nova Scotia. The necklace pairs a 5x5 grid of programmable RGB LEDs with an ESP32 board, and it is a nice example of how far a small matrix can go. Coming soon - so if you've made it this far into the post - you're in on our little secret!
A quick plan for this week
- Pick one effect and one place on the garment. Fewer, better ideas beat a crowded costume.
- Prototype on the bench with a ring or short strip.
- Move to your ESP32 board and test power draw with the battery you plan to use.
- Sew or mount it, then do a full walk-around test before the event.
Tell me what you are building. I read every comment, and I love seeing what the community comes up with.