Details
It's one of the lowest-power IMUs around (under 1 mA with both sensors running), which makes it a great fit for battery-powered wearables. It also has built-in step counting, tap and significant-motion detection, so your microcontroller can sleep until something actually happens. The onboard regulator means it runs happily from 3.3V or 5V, over I2C or SPI.
Specifications
- Sensor: Bosch BMI160, 16-bit
- Accelerometer range: ±2 / 4 / 8 / 16 g
- Gyroscope range: ±125 to ±2000 °/s
- Interface: I2C (address 0x68 or 0x69) or SPI
- Supply voltage: 3–5V (onboard regulator)
- Extras: step counter, tap/double-tap, significant motion, 2 interrupt pins
- Headers: included, not soldered
Pin Definitions
- VIN — Power in, 3–5V
- 3V3 — 3.3V regulated output
- GND — Ground
- SCL / SDA — I2C clock / data (also SPI clock / data in)
- CS — SPI chip select (leave high for I2C)
- SAO — I2C address select / SPI data out
- INT1 / INT2 — Interrupt outputs
- OCS / SCX / SDX — Auxiliary sensor interface (advanced)
Project Ideas
Gesture-controlled sleeves, light-up shoes that react to each step, dance and performance costumes that change colour with movement, posture reminders, or a wearable that wakes up when you pick it up.
Pair It With
Pair it with a compact board like the Adafruit ESP32-C3 QT Py or the sewable Beetle ESP32 [Sewable]. For flexible wiring inside clothing, try our soft silicone wire sampler.
In the box
- BMI160 6-axis IMU module × 1
- Header pins × 1 set



